Martin-sprocket-gear Drag Conveyor Safety User Manual

DRAGCONVEYORSAFETYINSTALLATION • OPERATION • MAINTENANCEINSTRUCTIONS3600 McCart Avenue • Fort Worth, TX 76101-1038817-258-3000 • (FAX) 817-258-3173

Before any maintenance or inspection is performed, refer to ANSI Standard ANSI Z244.1 for minimumsafety requirements covering LOCK OUT/TAG OUT ALL POW

Suggested Inspection ScheduleBefore any maintenance or inspection is performed, refer to Martin Drag Conveyor Safety • Installation •Operation • Maint

Vendor ContactGEAR REDUCERSSUPPLIER PHONE NUMBER ALTERNATE CONTACTDODGE 803-297-4800 Fax: 864-281-2381FALK 414-342-3131 Fax:414-937-4359NORD 608-849-7

Recommended SparesThe list of components provided below is our recommendation for spares required for generalmaintenance. Please use the enclosed bil

General Bolt Tightening TorqueThreadTensile StressAreaSAE Grade 2 SAE Grade 5 SAE Grade 8Size Tsa75% Yield Strength (PSI) - 43000 75% Yield Strength (

Screw conveyor inventories support the localdistributors.Martin SPROCKET & GEAR, INC. • 3100 SPROCKET DR. • ARLINGTON, TX 76015 • 817-258-3000For

It is the responsibility of the contractor,installer, owner and user to install,maintain and operate the conveyor,components and, conveyor assemblies

CEMA Safety LabelsThe CEMA safety labels shown below should be used on screw conveyors, drag conveyors, and bucket elevators.Safety labels should be p

CEMA Safety LabelsPlacement GuidelinesProduct: Screw ConveyorsEquipment:SC-1Drag ConveyorCVS930010“B”NEAR SIDEFAR SIDEUSE LABEL “A” ON BELT GUARDUSE L

THESE CEMA SAFETY LABELS CAN HELP MAKE YOUR CONVEYINGEQUIPMENT OPERATIONS SAFERExposed movingparts can causesevere injuryLOCK OUT POWERbefore removing

2InstallationRECEIVINGImmediately upon receipt all items in the conveyor or component shipment should be checked againstshipping papers for shortages

Installation3For shop assembled conveyors, units are match marked and shipped in longest sections practical forshipment. Field assembly can be accompl

OperationLubricate all bearings and drives per service instructions. Gear reducers are normally shipped withoutlubricant. Refer to service instruction

Problem Cause / Remedy Chart5PROBLEM CAUSE REMEDYPREMATURE TROUGH FAILURE A) Gauge too light A) Increase thickness. Consult catalog materials table /